Automatically adding mass to the weldment cut list properties
Tips and Tricks • Bill • 19 October 2015
When you create a new weldment part the mass of the weldment is not included in the weldment cut list properties, you have to manually add it in.
However, you can have the mass automatically included in the cut list properties by using a template. The attached video shows how this is done.
In fact, this technique can be used to add any additional custom properties that you want. The only down side I can see to this technique is that you have to remember to use this template when you create a new weldment part, but I don’t think that’s too hard.
